|
|
SALES - SERVICE - PARTS |
|
|
Pond Fountain Replacement
Pumps
- Below are some of the most common
replacement pumps that can be used on our RHP Series, Sugar Creek
Fountains', Eco Series, and other similarly built fountains.
- See bottom
of page for clearance specials
- 1/2 HP Replacement Pump
- 115-volt / 230-volt
- 4100 GPH
|
- 1/2 HP Wet Rotor Pump
- 115-volt only
- 6077 GPH
|
- 3/4 HP Wet Rotor Pump
- 115-volt / 230-volt
- 6605 GPH
|
- 115-volt Sugar Creek Replacement Pump
- Fits: Eco Series & MPS Units
1/2 HP
100' power cord
115 Volt
4100 GPH
820 Watts (Max) 7.1 AMPS
1-1/4" Threaded Discharge
- One Year Limited Warranty
Debris filter included
|
- 230-volt Sugar Creek Replacement Pump
- Fits: Eco Series & MPS Units
1/2 HP
100' power cord
230 Volt
4100 GPH
730 Watts (Max) 3.2 AMPS
1-1/4" Threaded Discharge
One Year Limited Warranty
Debris filter included
|
- 115-volt Wet Rotor Pump
1/2 HP
- Available with:
30' power cord to be attached to your cord
- OR 100'
power cord
115 volt
6077 GPH
520 watts / 4.5 AMPS
- Included:
1-1/4" threaded discharge pipe
- Intake debris filter
-
- 3M Splice Kit included with
30' cord option.
Many pump failures
are a direct result of water with high dirt and mineral concentrations
which cause
overheating and ruin the seals that protect the pump motor. Our
wet rotor pumps eliminate seal failure and allow for thorough
maintenance & cleaning.
One Year Limited
Warranty
|
- 115-volt Wet Rotor Pump
3/4 HP
- Available with:
30' power cord to be attached to your cord
- OR
100' power cord
115 volt
6605 GPH
593 watts / 5 AMPS
-
- Included:
1-1/4" threaded discharge pipe
- Intake debris filter
-
- 3M Splice Kit included with
30' cord option.
Many pump failures
are a direct result of water with high dirt and mineral concentrations
which cause
overheating and ruin the seals that protect the pump motor. Our
wet rotor pumps eliminate seal failure and allow for thorough
maintenance & cleaning.
One Year Limited
Warranty
|
- 230-volt Wet Rotor Pump
3/4 HP
- Available with:
30' power cord to be attached to your cord
230 volt
6605 GPH
600 watts / 3 AMPS
-
- Included:
1-1/4" threaded discharge pipe
- Intake debris filter
-
- 3M Splice Kit included with
30' cord option.
Many pump failures
are a direct result of water with high dirt and mineral concentrations
which cause
overheating and ruin the seals that protect the pump motor. Our
wet rotor pumps eliminate seal failure and allow for thorough
maintenance & cleaning.
One Year Limited
Warranty
|
T-10000 Pump
Cal Pump T10,000 Torpedo Pump,
9600 gallons per hour (160 gpm), 10 amps, 1100 Max Watts, water
cooled (no oil), stainless steel motor, high impact, non-corrosive
outer housing. 100' power cord.
(This pump is NOT compatible
with our 26" float and 1.5" nozzles it is meant to
be paired with our 36" float and 3" nozzle)
SORRY. Currently out
of stock |
|
- Clearance
Parts
- *Limited Supply*
14 AWG 3C SJTW Power Cord
Approximately 95 feet of 14 AWG
3C SJTW, 300V jacket with molded plug end.
Add 3M 82A1 underwater splice kit
at checkout for $37.00
Secure Online Checkout....$65.00
|
WARRANTY
NOTE:
Any pump that proves
defective by reason of improper workmanship of material within
one year of purchase, will need to be returned (at buyer's expense)
to The Fountain Guys, Ltd, for inspection prior to determining
warranty repair or replacement.
We do understand
the cost and inconvenience and strongly urge our clients to check
prices with UPS, FedEx and the Post Office.
Note: The original
pump, wire and attached waterproof splice must be returned, in
its entirety for pump warranty consideration, any deviation from
this requirement will void all warranties.
WARNING: These
pumps are not designed for use in salt or brackish water.
Water with high concentrations of salt, sand or minerals is very
corrosive to seals and bearings.
Please be aware that these conditions will affect the longevity
of your pump and may cause damage that is not covered under the
manufacturer's warranty.
|